KMC Clock RCA 2600-3 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 10
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
Page 8 of 10
RCA 2600 Series Installation/Operation Guide
Rev C
KELLY MANUFACTURING COMPANY
KMC
KMC Publication No.1401-1
SECTION 4, GENERAL INFORMATION
4.1 Instrument Care
The most easily damaged part of your instrument is the screen. Special care should be taken when cleaning the screen to prevent
scratches and other damage. Avoid touching the screen at all times.
To clean light spots and dust, use a soft, lint free cotton cloth slightly moistened with distilled water.
For harder to clean spots, use a 50/50 solution of isopropyl alcohol and distilled water. Vinegar may also be used in a 50% solution
with water. You may also use cleaners approved for LCD TV’s and laptop computer screens.
Always apply the cleaner to the cloth and not the screen.
-CAUTION-
Do Not use paper towels, facial tissue or napkins. These products are made from recycled paper and
may contain metals and wood chips that will scratch the screen.
Do Not use acetone or cleaners containing ammonia.
By avoiding all screen contact and by using proper cleaning methods, the user will be rewarded with many years of service.
4.2 OPTIONAL SLIP INDICATOR
An optional Slip/Skid Indicator (inclinometer)is available for the RCA2600-3 and RCA2600-2. The inclinometer can be purchased
with the slip indicator at time of purchase or separately installed by the user (part number 444-0010-01). The addition of an incli-
nometer satises the requirements for FAA’s AC 91-75. The slip indicator may be attached before or after the instrument has been
installed in the aircraft.
INSTALLATION
1. Apply power to the instrument to assure that it reads level in pitch and roll.
2. Remove two screws on the face of the instrument.
3. Align Inclinometer with holes and replace screws. Do not tighten.
4. Adjust the Inclinometer until the bubble is centered and tighten screws just enough to secure Inclinometer. Do not
over tighten.
SCREWS
SLIP INDICATOR
DIM
Figure 4.1, Inclinometer Installation
Vue de la page 7
1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire